
ACS-2210A User Manual
15. FP1: (2.0mm Pitch 2X5 Pin Header), Front panel connector.
Pin1-3:
HDD LED, They are used to connect hard disk activity LED. The LED blinks when the
hard disk is reading or writing data.
Pin2-4:
POWER LED, They are used to connect power LED. When the system is powered on
or
under S0/S1 state, the LED is normally on; when the system is under S4/S5 state, the
LED is off.
Pin5-6:
POWER on/off Button, They are used to connect power switch button. The two pins
are
disconnected under normal condition. You may short them temporarily to realize
system
startup & shutdown or awaken the system from sleep state.
Pin7-8:
RESET Button, They are used to connect reset button. The two pins are
dis-connected
under normal condition. You may short them temporarily to realize system reset.
Pin9-10:
WAN LED, They are used to connect WAN LED.
Note:
When connecting LEDs, pay special attention to the signal polarity. Make
Comentarios a estos manuales